Some New suggestions

[Whinis]

Here is a couple suggestions that I thought up
Sorry if they have already been suggested I had little time to post this



1. Data transferrer: Add a new Output being Linked that outputs 1 if it is linked and a 0 if not

2. Wired Winch: I have problems with fine control with it like I do with the non wired one for example if I put the non wired ones speed on 5 it goes Very slowly allowing me to change things slowly like moving an object. Yet if I set the button I use for the wired winch to one and debug it it takes leaps of 13 in length making it nearly impossible for fine control even if the button is under one it acts like its one

3. Wired Hydraulic: I Would love for it to have an in and out instead of just length as I have some props where just setting length can be a mistake.


Now before anyone comments telling me why don't you just use a wired numpad.......

I use wiremod so I can get away from numpad not so I can have 10 wired numpads plus what happends when I run out of numpad inputs.

[tomb332]

Mkay,
1. That sounds feasible, will do when i have 5min.
3. How would in and out be defined? Also to avoid numpads you can use if gates, wire B to your extended length, C to your contracted length and A to a 1,0 in,out output from your control circuitry, then wire the hydraulic to the if gate.

[Whinis]

3. How would in and out be defined? Also to avoid numpads you can use if gates, wire B to your extended length, C to your contracted length and A to a 1,0 in,out output from your control circuitry, then wire the hydraulic to the if gate.

well I understand that with length you can make it jump between lengths with a if statement and have done so with E2 but the problem is that when you do that it tends to jump to that length faster than I would like for some contraptions.

So I would love for there to be a simple for the hydraulic to act like a winch but being solid as in it can push and pull instead of just pull.

In and Out would simply Work like this
if Out=1 then Hydraulic Expands if In=1 hydraulic contracts There might be a place for extended and contracted to so you can state where its maximums and minimums are but thats not a requirement as you can just wire the output length into E2 and tell it if x>b then Button=0 . I am just simply asking for the wired hydraulic to be a little more like the non wired one.

Edit: also for number 1 could we also make an output for showbeam like with rangers...... it can be quite anyoing if you are trying to hide the transferers

[ZeikJT]

If it goes too quickly you can always set up a smoother, yes it's a separate gate.

[tomb332]

All hail the smoother!

[Jat Goodwin]

All hail the smoother!

The most underrated gate!

[Black Phoenix]

The most underrated gate is the Identity gate. Without it some contraptions would be impossible actually.