E2 Shield

[Neotic]

Heya, thought i'd make an E2 Power Shield just to see if it could be done relatively simple and it could yey, just one minor problem, it ain't pretty :/.

At the moment i'm using 2 holos of dome2 which give a disticnt line down where the 2 models split, i use them since using a sphere makes the shield invisible on the inside, since it's solid and you are "inside the model".

Here, i took a short vid of it:



Anyone got a solution to my cosmetic problem? ^_^

[thetree]

Havnt done it in a while - but I think you have 2 holos, one inverted and the other normal.

holoScale(1,vec(10,10,10))
holoScale(2,vec(-10,-10,-10))

Like that, to make a 10 by 10 by 10 holo.
They both need to be in the same place, same colour - all that.

tree

[Neotic]

Didn't work (technically did the same before except i turned one of the holos by 180 degrees) still have the small gap between them, and even if i close em up i'd still have a line, is there any way to either see the spheric models from the inside or is there a hollow spheric model?

[StefanMajonez]

That^, and I'd make them spheres, not domes.

[Neotic]

That^, and I'd make them spheres, not domes.

what?
and if you had read my post you would know i use domes because the spheres aren't hollow and you can't see the shield from the inside because of that

[Colonel Thirty Two]

Scale a second sphere by -Scale then.

[Neotic]

Worked perfectly, thank you yet again initrd.gz

[Warlock]

can you release this please, it will be really usefull

[thetree]

Worked perfectly, thank you yet again initrd.gz

wtf thats exactly what I said to do?

[Neotic]

wtf thats exactly what I said to do?

I understood yours as negatively scaling one of my 2 domes, you didn't say anything about using spheres instead of the domes mate