E2 Elevator

[xljplx]

ok so i have been trying to make an elevator with expression 2

i have made the code all works fine, the only problem is when i press 3 (third floor) it goes so fast that it kills you. im doing this with a phx 2x2 and i tried setting the weight higher and lower, nothing changes. please help? :/

[Squeakyneb]

http://www.wiremod.com/forum/help-su...eans-read.html

it's linked at the top of the page. Post code, screencaps etc.

[mattwd0526]

Fixed hydraulics/slider often mess up in garrysmod, you could try, rather than pushing upwards, lifting upwards with non-fixed hydraulics, then putting ONE slider in the guide it. This has worked for me fairly well in the past.

[Ecelleon]

try using a smoother in the Wire-Time section. This will gradually feed the hydros a value at a rate you set, i suggest 46.

[Manslaughter]

I have one that can go any floor just put gps at the floor and you can customize the speed/acceleration...
Im adding the finishing touches now... il upload some time soon... keep an eye out.

[mattwd0526]

Same-ish, just instead of acceleration you can modify the size of the arc (it arcs between the two points).